pottay

Hi All! Looking for a serial cable to download my phone book from old samsung (SCH N191) phone) I am using the PC Link 1.0 available at samsung site. The phone starts to communicate with USB cable but it says the model not supported with PC Link 1.0. Tried to make one serial cable on my own but nothing works. I used an old LG serail cable and changed the pin numbers at the Handset end as follows: TX - 5 RX - 6 GND - 8 Can someone help?

I converted the USB cable into serial one by using the MAX232 chip. Now when I connect my samsung 191 on COM2 and run uniCDMA, upon activating the DM mode ithe phone shows the display 'AUTO CDMA" 'suspend' and resets itself. Why is this happening and what is the remedy? Cam any one help. Could not read the eprom at all.

Hi Guys! As regards the Hexadecimal problem, I think any scientific calculater can do the job. Or else one can get help from a younger sibling - prob a student of secondary schooling. It is only a matter of multiplying the digits with their respective place values and adding the products. With regards to the confusion of detecting the phone with Bitpim etc, I would like to mention here that a lot depends on ones PC hardware. Still I would suggest, it is best to use a serial cable and not the USB one. coz not all softwares are written to read USB. One needs a good USB to serial driver to create a virtual COM port and then the USB cable might work. I am myself also working on it and will post any new developments.

You may kindly pin point the exact topic under which I may find the solution for the port problems if you can remember the same please.

Thanks, But under the device manager-> Hardware -> I can only see two entries for the USB devices ..1Intel USB........ controller and USB root Hub. From where should I change the port for my USB port to COM 1 or COM 2?

Thanks Vishal. I could Dload it. I also have the same quarry. The cables normally available in the market are USB port. Can uniCDMA or BtPIM detect it? Is there any place where serial cable are available or can we convert the USB to serial? Regards

Hi! I am new to the forum. Can some of my seniors help me out. I need UNICDMA software. Does it support USB port too? What is BitPim? I am a new learner and this is for experimental purposes only. Regards Pottay