nikme

Samsung offer jio Sim working on iPhone but only data calls not working.

One for me please.

You will get a used RE for 80k maybe even less if u go for 3-4 yrs used thunderbird. best would be get a Electra as it has the best thump And if u never had a RE before don't go for old bullets as they are nice to ride but difficult to maintain.

Best is download stock kitkat rom in your computer and Odin it.

You can update to kitkat everything working fine.

After you turn off the lock put the sd with jacket into a card reader and try ?

Do u put those command to write akey in 4.2.2 through terminal in CDMA workshop adb commands ?

put your micro sd card in a jacket(usually it comes in box with indian phones) and turn off the lock in jacket it will be fine it is also called micro sd to sd card adapter

this solution is to fix the proximity sensor which goes bad sometimes and even after the call the screen stays black until the person on line cuts the phone or if you press the power button this happens due to dirt and dust accumulating over sensor. so to check if your sensor is working properly do the below test to check sensor dial *#0*# and select sensors(tested on note 2,s4,note 3) when u put your hand on proximity sensor screen turns green with vibration and when u lift your hand it turns back to white but if it doesnt turn white after removing hand that means the sensor has a problem so we lower the value at which the sensor responds note :-you need to be rooted to follow this procedure open cmd and change to your adb folder and type the following command adb shell (you will get a notification on your phone screen accept it) su (give root privilege in phone) echo 0 > /sys/devices/virtual/sensors/proximity_sensor/prox_cal echo 1 > /sys/devices/virtual/sensors/proximity_sensor/prox_cal NOW cat state # put your finger on the sensor and check the value (my came 255) now remove your finger from sensor (it came 51) cat state # This returned 255 #finger on the sensor and 51 #blank value and then do cat /sys/devices/virtual/sensors/proximity_sensor/prox_cal this returned 0,60 45.....so my offset was 0. Ths sum of offset and #blank value was 0 + 51 = 51 that is equal to 33 in HEX. so i increased to 55 and hex value 37 then echo -en $'\x37' > /efs/prox_cal the value 37 will change according to your phone do the above math chown system:system /efs/prox_cal chmod 644 /efs/prox_cal sync reboot now the sensor is working you can check again by dialing *#0*# and do the test again

Did u try doing a factory reset from recovery? Google for how to enter recovery in xperia dual and in recovery do a factory reset see if that works

There's is already a thread in this forum U have to downgrade your modem to mdc and run the tool.

This method works , that's why it is posted here !!Sent by Moto G on Reliance CDMA Didn't work for me I tried flashing nae rom through recovery after flashing mk2 stock rom and philz recovery But it fails. Gsm unlock is possible though in mk2 or mja 4.3

Happy B'day!! Guru Gopalji Have a good one

Don't need to unlock again

This method won't work if you are not on deodexed rom for stock rom try my method for unlock. http://forum.xda-developers.com/showthread.php?t=2682242